Model Fishing Boat

I made this wooden model boat from scratch using the plan below. I equipped it with electronic receiver and dc motor to make it remote controlled.

Since I had finished planking a single side, whole body bent, and to fix this curvature I sliced the boat into three parts then bent the boat back until the spine was straight again. Finally I reinforced the hull.
The rudder is connected to a servo motor. The shafts of the propeller and the rudder are piped to prevent water leaks.
I designed and 3D printed all the accessories.
I made the door handle by soldering and sanding some copper wire.
3D printed anchor.

<span>%d</span> blogcu bunu beğendi: